UTTERN D70 - Bow Anchor Windlass (Optional)

27
Uern D70 — System & Component Overview and Operaon
9. Bow Anchor Windlass (oponal)
The anchor windlass located at the bow of the boat assists with the anchoring of your boat by
automacally raising and lowering the anchor. The windlass is operated from the helm.
Operaon
To operate the windlass, the windlass breaker, located on the baery switch panel, must be turned
ON. Operaon of the windlass at the helm is controlled by a momentary switch used to raise and
lower the anchor. Pushing down on the switch will lower the anchor, while pushing up on the switch
raises the anchor.
Manual operaon
In the event that there is a loss of power, the windlass can sll be used to raise or lower the anchor
manually. If there is a loss of power, check the windlass breaker to see if it needs to be reset. If you
reset the breaker and it connues to trip, have your authorized Uern dealer inspect the system.
In order to manually operate the windlass and lower the anchor into the water, insert the emergency
handle (provided by the windlass manufacturer) into the star socket located at the top of the gypsy
cover and turn counter-clockwise. This loosens the clutch holding the anchor rode and chain in place
and allows the anchor to be deployed into the water. The speed of the rode can be adjusted by
turning the handle clockwise. To re-engage the clutch and lock the rode from moving, turn the handle
clockwise.
To manually raise the anchor, loosen the clutch by turning the handle counter-clockwise, and pull the
anchor up into the boat. Make sure to properly feed the rode and chain through the windlass when
pulling up the anchor. When the anchor is up and stowed properly in the bow pulpit, re-engage the
Exhaust gas is HOT. Ensure that there is nothing that is
suscepble to heat damage (i.e. ropes, fenders, other
boats) within 200mm of the exhaust outlet.
THE TANK OUTSIDE OF THE BOAT. When lled, re-install the cap, and secure the tank in the
entertainment center.
The stove is controlled by a keypad located on the vercal face of the entertainment center, behind
the a door. To use the stove, li up on the blower lid exposing the heat plate. Next, ignite the cooker
by pressing the heat switch on the control panel. The knob on the panel allows you to vary the stove
temperature for cooking.
The stove also comes equipped with a heat blower lid. The blower can only be used when the lid is in
the closed posion, folded over the heat plate. The control panel does allow for either automac
control of a preset temperature, or vary temperature manually. Refer to the owner’s manual for more
detailed instrucons.
Maintenance
Maintenance of the stove and heater will require you to check the ngs and hoses to make sure
that there are no leaks. If the system does require maintenance, contact your local dealer.
REFER TO OWNER’S MANUAL PACKAGE FOR INSTRUCTIONS AND WARRANTY INFORMATION.