UTTERN D70 - Cockpit Table; Sun Lounge (Optional)

Uern D70 — System & Component Overview and Operaon
36
20. Cockpit Table
Your boat is equipped with a rectangular teak table. To install the table, rst remove the plasc cover
located in the table base plate. Next, push and lock the table leg into the base plate. Finally, place the
table onto the table leg. When not in use, the table can be placed in a canvas bag and stored in the
starboard helm storage, while the table leg is stored in the L lounge seat base.
addional 50 degrees so that it lays at. With the provided sun lounge conversion ller and cushion,
the seat becomes a large area for sunbathing.
To return the backrest to it’s most up-right posion, simply li the lever again and rotate the seat back
up.
Cockpit Table
Table base
Table leg
Table
Do NOT run the boat while the a cockpit seat is laying at.
Uern recommends that when the engine is running, the
seat back is in it’s most up-right posion.
21. Sun Lounge
The cockpit of the D70 can be transformed into a sun lounge. To install, place the ller board into the
designed posion. The ller board edges will sit in the edge of the L-lounge. Make sure that you fold
down the support leg on the ller board. Next, place the sun lounge cushion on the ller board. When
not in use, the ller board can be stored on the head bulkhead.
Cockpit Sun Lounge
Sun lounge cushion
Filler board
Support leg