g. Press MODE again to enter transmission protocol setup
h. Press M+ to select protocol of P=N81 or P=E71
i. When the preferred transmission protocol shows on
display, press TARE to confirm and proceed to the
next selection or ON/ZERO to restart the scale
NOTE:
The default data output format of the scale is
Baud Rate = 9600
Data Bit = 8
Stop Bit = 1
Parity = None
4.2.4 Select Digital Motion Filtering Function
This indicator equipped with animal weighing function
that enables user to select when the indicator is using
for weighing livestock.
a. Scale is off
b. Press and hold TARE, then press ON/ZERO
c. Indicator displays F1
d. Press TARE five times to F6
e. Press MODE to select filter strength of 0, 1, 2, 3,
4, 5, 6, 7
- To enable Animal Weighing Function, press TARE
To Next Page
Loading...
