UWE APS - Page 16

c. Scale displays F1
d. Press TARE eight times
e. Scale displays F9
f. Press MODE to select between Tr_on or TroFF
-To enable Auto Tare Function, press TARE when Tr_on
appears
-To disable Auto Tare Function, press TARE when TroFF
appears
g. After TARE is pressed, scale display F10
h. Press MODE to enter next set up or ON/ZERO to restart
the scale
4.2.8 Select Original Calibrated Zero Function
This scale is equipped with original calibrated zero
function that enables user to select if the original
calibrated zero is required to utilize as the weighing
base for initial power-on status.
a. Scale is off
b. Press and hold TARE, then press ON/ZERO
c. Scale displays F1
d. Press TARE nine times
e. Scale displays F10
f. Press MODE to select between AC_on or AC_oF
-To enable Original Calibrated Zero Function, press