UWE APS - Page 18

-To enable Accumulation Function when pressing M+,
press TARE when Ad._on appears
-To disable Accumulation Function when pressing M+,
press TARE when Ad._oF appears
g. After TARE is pressed, scale display F13
h. Press MODE to enter next set up or ON/ZERO to restart
the scale
4.2.10 Select Number of Printout Copy (This function
is UTP printer related)
9 parameters (copy 1 to copy 9) are available. Select
the required number of printout copy here.
a. Scale is off
b. Press and hold TARE, then press ON/ZERO
c. Scale displays F1
d. Press TARE eleven times
e. Scale displays F13
f. Press MODE to select number of printout copy of
COPY1 ~ COPY9
g. When preferred number of printout copy shows on
display, press TARE to confirm.
h. After TARE is pressed, scale display F14
i. Press MODE to enter next set up or ON/ZERO to restart
the scale
4.2.11 Select Total Print when Performing Memory-clear