Refer to SPECIFICATIONS for maximum zero range.
NOTE:
-When scale is set at OIML and application is legal for
trade. User only needs to press ON/ZERO once when setting
the value to zero. The re-zero function will take place
when reading is stabled
-When scale is set at Normal and application is not legal
for trade. User can set the value to zero at anytime
when pressing ON/ZERO
5.6 TARE OFF THE WEIGHT OF A CONTAINER
When a container is used, follow the below steps to
manually tare off the weight of container and get the
net weight.
a. Remove all loads away from platter
b. Make sure that the ZERO INDICATOR is on
c. Place the container on the platter
d. Press TARE
After TARE is pressed, the NET INDICATOR would appear.
Refer to 5.2 for weighing procedures. Weight displayed
under is the net weight of the subject matter. Refer
To Next Page
Loading...
