V-Tec 2Easy DMR18s - Work Mode Settings

2 EASY
Total four different work modes are available for DMR18S to accom-
modate different situation. In standby mode, input #8002 + code
(66666666) and select “ 5 ” item to enter
Work Mode
setting page.
Work Mode
set to 0;
The
Standard Mode
is applied in a small capacity system, which
monitors are under 32 and without BDU unit. Generally dial 01~32 to
call the monitor.
Work Mode set to
0
, and ID code set to
0~3.
Input Mode:
In standby mode. Input #8001+ Code( 66666666 by
default), then select “ 5 ” item to set the
Doorplate Mode
, for example
input the code 15 to call the monitor.
Input Mode
: In standby mode. Input #8001+ Code ( 66666666 by
default), then select “ 5 ” item to set the
Doorplate Mode
, for example
input the code 068 to call the monitor.
Work Mode
set to 1:
The
DT-DJ Mode
is used for the audio intercom system. When the
system contains of the audio monitors, such as DJ4A, DJ5A, DJ6A,
etc. The
DT-DJ Mode
can be assigned the address from 001 to 128
without BDU unit.
Work Mode set to
1
, and ID code set to
0~3.
DEFINITION
STANDARD 32 APARTMENTS
DT-DJ MODE
* Cancel # Save
(0~3)
[ 0 ]
5. Work Mode [0]
* Cancel # Save
(0~3)
[ 1 ]
5. Work Mode [0]
* Cancel # Save
[ * * * * * *1 1 ]
5. Doorplate Mode [11]
0: *
1: 123
2: ABC
3: -
* Cancel # Save
[ * * * * * 1 1 1 ]
5. Doorplate Mode [111]
0: *
1: 123
2: ABC
3: -
* Cancel # Save
(0~3)
[ 0 ]
1. ID Code [0]
* Cancel # Save
(0~3)
[ 0 ]
1. ID Code [0]
CONFIGURATIONS
Work Mode
DMR18S Technical Menu-8-
When door station is in
standby, press '#' key
Input '8002', then input the
Admin Code.(66666666
by default)
Select “5” to enter
Work Mode page.
[ 8002 ]
Please Input Password
1 2 3
654
7 8 9
#0
*
RF CARD
Press No.
to select
*Back
Setup
1. Language [0]
2. Tone Select [01]
3. Tone Volume [3]
4. Unlock Code [1111]
5. Work Mode [0]
6. Clock ...
7. Setup Code ...
8. About ...
9. Default ...