V-Tec DMR18S - Door Station Configurations; About Room Code (Address); About Debug State; About Debug Tools

6. Door Station Congurations
1. About room code(address):
RoomCode(alsocalledroomaddress)isacodeassignedtoeachmonitor,toidentifydifferent
monitors;eachmonitorhaveauniqueroomcodeinonebuidling.TheroomCodeisstoredin
eachMonitor’sinnerEEPROMmemory,anddoesnotloseeventhemonitorispoweroff.
2. About Debug State:
TheDebugStateisyourstartingpointforusingalltheapplicationsonDMR18S.
WhenDoorStationisin
standby,press'#'key
Press"2#"keytoexitoutthedebugstate.
input'9008',theninputthe
AdminCode.(66666666by
default)
DebugStatemenuislaunched
[ 9 0 0 8 ]
Please Input Password
1 2 3
654
7 8 9
#0
*
RF CARD
>> Debug State <<
1-# Tools
0-# Redial
2-# Exits
3. About Debug Tools:
DuringworkingatDebugState,press"1#"toentertoolspage,DebugToolsoverviewsis
shownasbelow:
1. Installer Setup
2. Setup
3. Card Manage
4. Online Monitors
5. Online Devices
6. Voltage Measure
Pres NO.
to select
*Back
Tools
>> Debug State <<
0-# Redial
2-# Exits
1-# Tools
-7-