V-Tec DT591 - Electric Lock Connection; Door Lock Control Setup; Door Lock Controlled with Internal Power; Door Lock Controlled with Dry Contact

-5-
5.2 Electric Lock Connection
5.2.1 Door Lock Controlled with Internal Power
connect one lock connect two locks
Note:
1. Electronic lock of Power-on-to-unlock type should be used.
2. The door lock is limited to 12V, and holding current must be less than 250mA.
3. The door lock control is not timed from Exit Button(EB)
4. The
Unlock Mode
Parameter of Monitro must be set to 0 (by default)
12
ON
1 2 3
-
+
BUS PL S1+ S2+ S-
-
+
Jumper position in 1-2
lock #2
lock #1
EB
EB
12
ON
1 2 3
-
+
BUS PL S1+ S2+ S-
Jumper position in 1-2
EB
5.2.2 Door Lock Controlled with Dry Contact
Note:
1. The external power supply must be used according to the lock
2. The inside relay contact is restricted to AC or DC 24V/3A
3. The jumper must be taken off before connecting
4. Setup the
Unlock Mode
of Monitor for different lock types
• Power-on-to-unlock type:Unlock Mode=0 (by default)
• Power-off-to-unlock type:Unlock Mode=1