VAC V200 POSITIONER - 4 Specifications; Specifications Feedback Options

92077r14
www.vac.se
V200 POSITIONER
12
4. SPECIFICATIONS
4.1 Specications feedback options
Mechanical Switch module
Type:SPDT,V3(CamdenCMNS2020D)
Maximum load:
Resistive (Inductive) Voltage
 10A (3)A 250 VAC
Reed Switch module
Type:SPDT-CO,FormC(Hamlin59145-3S02A)
Contact rating: max 3W
Voltage switching: max 175 VDC
Voltage breakdown: min 200 VDC
Current switching max 0.25 A
Current carry max 1.5 A
Contact resistance: 0.2 Ohm
Contact capacitance: 0.3 pF
Mechanical and electrical life: Over 100 million operations.
Inductive Sensors (NAMUR) module
Type:NAMUR2-wire,V3(P+FNJ2-V3-N)
Power supply: 5-25 VDC, 2-wire
 Outputsignal: Targetabsent(o󰀨)>3mA(15mAmax.)
  Targetpresent(on)<1mA
 Hysteresis: 3-15%(5%typical)
Repeatability: <.01mm
Operatingtemperature: -14to+212°F(-10to+100°C)
4-20mA Position Transmitter module
Voltage supply: 7-30 VDC
Output: 4-20mA, 2 wire
Loop Impedance: max 850 Ohm @ 24 VDC
Linearity error: <1.2%
Hysteresis: <0.2%
 Temperaturesensitivity: <0.1%/10°F(5.5°C)
Potentiometer module
 Output: 10kOhm(5kOhmor1kOhmoptional)
Resistive element: Conductive plastic
 Powerrating: 1W@158°F(70°C)
Linearity error: <1%
 Resolution: Innity