Vacon NXI - Fault History Menu (M5)

control keypad vacon • 77
24-hour support: +358-(0)40-8371 150 • Email: vacon@vacon.com
7
7.3.5 Fault history menu (M5)
Vikahistoriavalikkoon
pääsee Päävalikosta painamalla Oikeanpuoleista valikkonäppäintä kun You
can enter the
Fault history menu from the Main menu by pressing Menu button right when the
location indication
M5 is visible on the first line of the keypad display.
All faults are stored in the
Fault history menu where you can browse them with the Browser buttons .
Additionally, the
Fault time data record pages (see Chapter 7.3.4.3) are accessible for each fault. You
can return to the previous menu any time by pressing
Menu button left .
The memory of the inverter can store a maximum of 30 faults in order of appearance. The number of
faults currently in the fault history is shown on the value line
of the main page (H1H#). The order
of the faults is indicated by the
location indication in the upper left corner of the display. The latest
fault is indicated by F5.1, the one before that by F5.2 and so on. If there are 30 uncleared faults in the
memory, the next fault will erase the oldest fault from the memory.
Pressing the
enter button for about 2 to 3 seconds resets the whole fault history. The symbol H# will
change to
0.
Figure 7-4. Fault history menu
H1
H3
READY
I/Oterm
T1T7
I/Oterm
READY
I/Oterm
I/Oterm
READY
13:25:43
I/Oterm
enter
17
Fault history 11 Output phase
5 ChargeSwitch
Operation days
Operation hours
PUSH to reset