Vacon NXI - Keypad Settings Customization

control keypad vacon • 87
24-hour support: +358-(0)40-8371 150 • Email: vacon@vacon.com
7
Multimonitoring items (P6.5.4)
Vacon alphanumeric keypad features a display where you can monitor up to three actual values at
the same time (see Chapter 7.3.1 and Chapter
Monitoring values in the manual of the application you
are using). On page P6.5.4 of the System Menu, you can define whether the operator can replace the
values monitored with other values. See below.
Figure 7-13. Disabling the change of multimonitoring items
7.3.6.6 Keypad settings
In the Keypad settings submenu under the System menu, you can further customise your inverter
operator interface
.
Locate the Keypad setting submenu (S6.6). Under the submenu, there are four pages (P#)
associated with the keypad operation:
Figure 7-14. Keypad settings submenu
Default page (P6.6.1)
Here you can set the location (page) to which the display automatically moves when the Timeout
time
(see below) has expired or the power is switched on to the keypad.
If the Default page is 0, the function is not activated i.e. the latest displayed page remains on the
keypad display. Pressing
Menu button right takes you to the edit mode. Change the number of the
Main menu with the
Browser buttons . To edit the number of the submenu/page, press Menu button
right
. If the page you want to move to by default is at the third level, repeat the procedure. Confirm
the new default page with the
enter button . You can return to the previous menu at any time by
pressing
Menu button left .
Figure 7-15. Default page function
READY
I/Oterm
READY
I/Oterm
enter
READY
I/Oterm
Multimon. items
ChangeEnable
Multimon. items Multimon. items
ChangeEnable ChangeDisable
P1P5
READY
I/Oterm
0.
READY
I/Oterm
Keypad settings
Default page
0.
READY
I/Oterm
READY
I/Oterm
READY
I/Oterm
0.
1.
enter
Default page
REPEAT TO SET
DEFAULT SUBMENU/PAGE
CANCEL
Default pageDefault page
CONFIRM CHANGE