EN_25
Electrical and electronic apparatus must be eliminated
according to European Directive 2012/19/UE. This equip-
ment CANNOT be eliminated according to the normal fl ow
of urban solid waste but must be collected separately so
as to optimize the recovery and recycling of the materials.
The symbol of the crossed-out waste-paper-
bin appears on all the products to remind
you of the obligation of selective collection.
Observing correctly all the provisions relating
to the elimination of old products, you will
contribute to protecting the environment.
9.1 Disposal
9.Disposal
10.1 Troubleshooting
10. Troubleshooting
Issues Causes Solutions
The machine does not turn on.
Main switch is OFF. Turn the switch to ON.
Plug not connected. Connect the plug to the right socket.
Leaking tap.
Tap seal not lubricated. Lubricate tap seal.
Damaged seal. Replace tap seal.
Loss of product from rear part of
the bowl.
Bowl not correctly assembled. Control bowl assembly.
Bowl seal not lubricated. Lubricate tap seal.
Damaged seal. Replace tap seal.
The mixer does not turn.
There are blocks of ice inside the bowl.
Let the product defrost and check that the
product is homogeneous.
The machine does not produce
slush.
Machine near heat sources.
Change machine position.
Machine with insuffi cient ventilation
Dirty fi lter. Clean the fi lter.
Erroneous regulation of consistency. Correctly regulate the consistency.
Noisy mixer
There is not enough product in the bowl Fill the bowl
The display shows an alarm.
Break-down or malfunction See Alarms or call technician
If the consistency of the product
is not adequate.
Consistency not adjusted Check the consistency Adjustement in the
menu.
In the event that the machine malfunction is not specifi ed in this table or the solution is not appropriate
to solve a specifi c problem, contact a specialist technician.
To Previous Page
Loading...