Vaisala HUMICAP HMP155 User Manual

Example
>intv 1 min
Interval : 1 min
>
4.4.4 SEND command
Use the SEND ADDR command, where ADDR is the address of the probe, to view the reading
once in the STOP mode.
You can use SEND without the address in the STOP mode. The output format
depends on the parameters the probe can print.
The following example shows SEND without a parameter.
>send
RH= 24.9 %RH T= 22.1 'C
>
4.4.5 SMODE command
Use the SMODE command to set the user port to permanent STOP, RUN, POLL, or SEND mode.
SMODE [xxxx]
The output mode you select is activated after power outages.
Parameter
Description
xxxx
STOP, RUN, POLL, or SEND
Table 21 Output modes
Mode Output Available commands
STOP Only with the SEND command All (default mode)
RUN Automatic output
S
POLL Only with the SEND [addr] command
??
SEND [addr]
OPEN [addr]
Chapter 4 – Operation
43

Vaisala HUMICAP HMP155 Specifications

General

Humidity Measurement Range	0 to 100 %RH
Operating Humidity Range	0 to 100 %RH
Protection Class	IP65
Measurement Parameters	Humidity and Temperature
Temperature Measurement Range	-40 to +60 °C
Temperature Accuracy	±0.2 °C
Operating Temperature Range	-40 to +60 °C
Humidity Sensor	Vaisala HUMICAP®