The following items are in charge of the OEM Plant (Bus Body Builder).
Problems with any driver´s air conditioning component, leakage, bad working or operation.
IMPORTANT: clean the return filter of the driver´s air conditioning, at least, once a week.
Bad attachment.
Leakage at connections and welding points.
Damages due to frictioning / chassis and components frictioning or bad installed.
Excess or lack of torque at attaching screws/bolts.
Assembly is out of project designs.
Pulleys are not aligned, excess or lack of stretchiness at the belts and pulleys.
Leakage test procedure.
Vacuum process and refrigerant gas charge.
Driver´s
Evaporator
hoses,
drains and
wiring harness
Alternator /
Compressor
Support
Gas Charge
Process
DD 430
Note: In case the installation is bad, VALEO Agent Authorized Service Net will have to call the OEM Plant first, then get an authorization to do the service,
print and issue the Invoice of repairs.
ATTENTION: Just in case a problem happens in the refrigeration system, then it must be repaired in an authorized shop or qualified professional.
If a third party installs the equipment, VALEO Climatização do Brasil - Veículos Comerciais S/A, guarantees only the product, not the installation of it.
IMPORTANT: the vehicle owner must do preventive maintenance actions. If you do not do the preventive maintenance
as described in this chapter, it implies you lose partially or full warranty coverage.
PREVENTIVE MAINTENANCE
To Next Page
Loading...
Need help?
General
