GLOBAL
10
From this menu, you can control the settings of or calibrate
your built-in expression pedal.
EXP Setting
There are four options within this menu: Target, Expression
Range, Volume Range, and Calibrate.
·Target
Under the Target option, you can set the pedal’s control
target. You can set up a maximum of four eects parameters
for the built-in expression pedal to control.
In the selection panel, Block X (X standing for 1-3 controllable
targets) represents the eects module in play. FX X displays
the actual eect name, and PARA X shows the eect’s
controllable parameter.
Use Quick access knob 1 to select the module placement. Use Quick access knob 3 to select the
eects parameter. Press the PARA button to flip through the panel. You can also turn the expression
pedal o by selecting OFF in the settings panel.
In the selection panel, MIN X (X standing for 1-3 controllable
targets) represents the lowest range value. This is the value
the pedal will have when pushed all the way up. MAX X
represents the highest range value, when the pedal is pushed
all the way down. The MIN and MAX range is 0-100, and the
MIN value can be greater than the MAX value.
·EXP Range
Under the EXP Range option, you can set the expression pedal
expression range and sweep curve. There are four adjustable
targets to change these settings.
Tap Tempo Mode
Tap Tempo Mode
PRE MOD DLY
CLOSE CLOSE CLOSE
In this menu, you can set whether all patches to accept the
impact of Tap Tampo.This function ignores the Sync settings
in the stored patches, but does not aect the stored patches.
The Sync function of the PRE, MOD and DLY modules in all the
patches can be aected by Tap Tempo.
After the synchronization is enabled, when you turn on Tap
Tempo, the Sync of the corresponding module will be opened.
You can control the time/speed value of the corresponding
module by Tap Tempo in any patch.
To Next Page
Loading...
Need help?
Audio Specifications
