52
9.4 SETTINGS OF THE STEP:
9.4.1 CHANGING OF THE SPEED
In actual step you can change mixer speed.
For this you must use the regulation buttons.
If you press the button you increase the
actual speed.
If you press the button you decrease
the actual speed.
If the racket - button is grey the increasing of the speed is not allowed.
If the snail button is grey the decreasing of the speed is not allowed.
In the most programs the permeted changing of the speed is saved.
See the relevant program info to check whether changes are stored. If changes
are NOT stored they will be valid only for the running program!
The new parameter is valid and used during the running program and will be
valid and used when running the program in future.
9.4.2 CHANGING OF THE TEMPERATURE
In actual step you can change desired
temperature. For this you can use two
buttons.
If you press the UP - button you
increase the actual temperature.
If you press the DOWN - button you
decrease the actual temperature.
For confirming the new value press the SET
button.
If the UP button is grey the increasing of the temperature is not allowed.
If the DOWN button is grey the decreasing of the temperature is not allowed.
In the most programs the permeted changing of the temperature is saved.
See the relevant program info to check whether changes are stored. If changes
are NOT stored they will be valid only for the running program!
The new parameter is valid and used during the running program and will be
valid and used when running the program in future.
To Next Page
Loading...
Need help?
General