Valor 203 User Manual

INSTALLATION GUIDE – 203 DISPLAY
www.valortpms.com
10
2.1 Turning Integrated Display On/Off
2.2 Programming Tire Pressure Baseline
The ON/OFF switch is located on the back of the Display.
Once the sensors have been installed in the tires and ID Modules inserted in the back of the Display, please
insure that all tires are at recommended/optimum pressure.
*Note: Tire should be cool before setting pressure baseline.
Press and hold the “Set Key” on the back of the display for 8-10 seconds, the display will beep and all pressure
readings will go to 00.0. The next pressure recorded by the sensors will be the set baseline.
To conrm the baseline is set, press the set key once when the axle in question is showing on the display.
Repeat for each axle.
PART 2 : System Programming
BUZZER
ON/OFF
SWITCH
SET KEY
AXLE
TOGGLE
PRESSURE AND
TEMPERATURE
TOGGLE

Valor 203 Specifications

General

Capacity	200 g
Readability	0.001 g
Display	LCD
Power	AC Adapter (Included)
Units	g
Measurement Range	0 - 200 g
Dimensions	196 x 223 x 73 mm
Weight	0.9 kg