OWNER’S GUIDE
Page 9
Figure 4. Replacing radiant (Shown with Firelite case)
CLEANING
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster. Obstinate marks can be removed from the guard
and trims using soapy water. Never use abrasive cleaners.
The radiants can be cleaned with a soft brush - see below for how to remove the radiants.
REPLACING THE RADIANTS
See figure 4.
Always use the
correct type of
replacement radiant.
Ask for Valor part
number 0544649 (GC
No. 125 164).
• Turn the fire off
and allow it to cool
before attempting to
remove the radiants.
• Remove the dress
guard by pressing
down the two hooks at
the top. Tilt the guard
forward and lift out.
• Lift the radiant
upward to clear the
metal retaining bar
then pull out bottom
first.
• Fit the new radiant
by inserting its top
under the top lip of the
radiant box then swing
the bottom of the
radiant over and
behind the retaining bar. It is important that the back face of the radiant should rest
against the rear ribs in the firebox. There will be a small gap between the bottom
front edge of the radiant and the retaining bar.
To Next Page
Loading...
Need help?
General
