Valor Firelite OXYSAFE 2 User Manual

600B691/08
OWNER’S GUIDE
THIS APPLIANCE IS FOR USE WITH NATURAL GAS (G20)
THIS APPLIANCE IS FOR USE IN THE UNITED KINGDOM (GB) AND THE
REPUBLIC OF IRELAND (IE) ONLY.
This guide is intended to help you care for your Valor gas fire. Please read thoroughly
before using and keep for future reference
We trust that this guide gives sufficient details to enable your appliance to be operated
and maintained satisfactorily. However, if further information is required, our
Valor Technical Helpline will be pleased to help.
Please telephone 08706 061 065 (National call rates apply).
This guide to be left with the owner
© Valor Heating
Firelite & Regency
OXYSAFE 2 OXYSAFE 2
MODEL 3370 MODEL 3371
(GC No. 32-032-31)
Contour
OXYSAFE 2
MODEL 338
(GC No. 32-032-32)
RADIANT/CONVECTOR
GAS FIRES

Valor Firelite OXYSAFE 2 Specifications

General

Brand	Valor
Model	Firelite OXYSAFE 2
Category	Indoor Fireplace
Language	English

Summary

Safety First

General Safety Approvals

Valor fires are CE Approved and meet British Standards and Safety Marks.

Quality Standards

Fires manufactured to BS EN ISO 9001 quality system by the British Standards Institute.

Industry Affiliation

Valor is a member of the Society of British Gas Industries ensuring high standards.

Installation Requirements

Must be installed by a CORGI Registered Installer, not directly on combustible floors.

Safety Procedures

Gas Leak Response

Steps to take if a gas smell is detected: extinguish flames, turn off gas, ventilate, call emergency services.

Installation Guidelines

Competent Person Installation

Installation must comply with Gas Safety (Installation & Use) Regulations and local rules.

Chimney and Shelf Clearances

Minimum 90mm clearance above appliance top to shelves; specific clearances for deeper shelves.

Fireguard Requirements

A suitable guard (BS 6539/6778) is recommended for protection of children, elderly, and pets.

Operating Precautions

Relighting Wait Time

Wait at least three minutes before relighting if the fire has been switched off or flames extinguished.

Wall Covering Suitability

Consider suitability of wall coverings near the fire; soft or raised patterns may scorch or discolour.

Side Clearance

Maintain a minimum 50mm clearance between outer case sides and combustible corner walls.

Prohibited Actions

Do not hang fabrics over the fire, fill behind case, use without dress guard, or clean while hot.

Appliance Dimensions

Operating Your Fire

Initial Use Odours

New appliances may emit harmless vapours causing slight odours that disappear with use.

Oxysafe Safety System

Flue blockage and flame sensing safety device; not a substitute for a Carbon Monoxide detector.

Pilot Light Ignition

Procedure to light the pilot using the control knob, including spark generation and flame viewing.

Heat Level Settings

Control knob positions (2-5) correspond to different radiant heat outputs (low to full).

Manual Pilot Ignition

Method for lighting the pilot with a match or taper if the ignition mechanism fails.

Cleaning and Maintenance

Cleaning Instructions

Clean only when cool; dust normally, use damp cloth for trims, soapy water for stubborn marks. Avoid abrasives.

Replacing Radiants

Step-by-step guide for removing the dress guard and replacing radiants, including part number.

Regular Maintenance

Flue and Obstruction Check

Essential to keep fire opening and flue clear of obstructions like mortar or soot for safety.

Mandatory Safety Checks

Landlords must have gas appliances checked annually by a competent person (UK law).

Servicing and Spares

Contact Valor Service or Spares for maintenance, advice, or replacement parts.