Using the Remote Control
6:00 am
P1
Start time
8:00 am
P1
End time
4:00 pm
P2
Start time
10:00 pm
P2
Start time
6:00 am
P1
Start time
Set temp 74ŐF Set temp 40ŐFSet temp 74ŐF
Set temp 40ŐF
Automatic Turn Down
6 Hour no Motor Movement
Manual Mode/Temperature/Timer Mode: The valve will
turn to pilot ȵ ame if there is no change in ȵ ame height
for a 6 hour period. In Temperature/Timer Mode if the
ambient room temperature changes, the ȵ ame height
will adjust automatically to maintain set temperature,
and the ȴ re will continue to function normally. The
valve will turn to pilot ȵ ame if the set temperature and
the ambient room temperature remain the same over a
6 hour period.
Automatic Shut-O
Low batteries receiver. With low battery power
in the battery holder the system shuts o the ȴ re
completely. This does not apply when the power supply
is interrupted.
On-Demand Pilot. This green feature eliminates
gas energy consumption during extended appliance
inactivity. When the appliance is inactive for 5 days
the system automatically extinguishes the pilot. This
feature helps the consumer realize cost beneȴ ts by
automatically eliminating energy consumption during
non-heating months and limited use.
Timer Programming Example (default temperatures shown)
ɄCaution
DO NOT USE a screwdriver or other metallic
object to remove batteries from holder. This
could cause a short-circuit.
Low Battery Indication
Handset: The battery icon will show when the bat-
tery needs to be replaced. Replace with one 9 V alkaline
battery.
Battery holder: Frequent ‘beeps’ for 3 seconds when
the valve motor turns indicate the batteries need to be
replaced in battery holder. Replace with four 1.5 V alka-
line batteries.
Handset / Receiver Match
The remote control handset and receiver are
programmed to function together. In case of a
replacement of the handset or the receiver, you will
need to reset the receiver to allow them to function
together. Contact your dealer for details.
Setting P2 ON and OFF times.
Repeat same steps as Setting P1 ON and OFF times.
When all settings are complete, press to save them.
OWNER’S
INFORMATION
11
To Next Page
Loading...
