Overview
This appliance may ONLY be installed in an existing unaltered,
functioning solid-fuel burning fi replace with a working fl ue and
constructed of non-combustible material.
DO NOT install into combustible construction. This appliance
is NOT APPROVED for installation with a zero clearance kit.
WARNING
HOT HEARTH / FLOOR! The
hearth or floor in front of the
fireplace may become very hot
when the fi replace heats. Do not use
the hearth as a seat or shelf. Solid
wood fl ooring in front of the fi replace
(if allowed) may shrink during the
heating season due to heat.
WARNING
Some materials or items, although
safe, may discolor, shrink, warp,
crack, peel, and so on because of
the heat produced by the fi replace.
Avoid placing candles, paintings,
photos, and other items sensitive to
heat around the fi replace.
WARNING
!
WARNING
!
785 fi replace
Chimney Terminal
Cap
Flashing
2 x 3” approved
fl ex chimney liners
running full length
Existing unaltered,
functioning solid-
fuel burning
fi replace &
chimney
Existing non-combustible hearth. Combustible
hearth of fl oors within 16” of insert must be a
minimum 4” (102 mm) below bottom of insert.
Gas insert does not require a hearth.
Trim
(sold separately)
QUALIFIED
INSTALLER
20
To Next Page
Loading...
