Refi t and Check Window
1. Place the window in its bottom railing and push its
top against the fi rebox.
Ensure to remove any
particles in the railing before installing the
window.
2. While you hold it, hook the side levers into the
window tabs.
3. Pull out the top of the window and release it to
ensure the springs return it.
4. Apply fi rm hand pressure around the window frame
to ensure the window is sealed tight against the
fi rebox.
Window
frame
Bottom
railing
Hot Glass Plate
WARNING
Failure to install the window correctly can
leak carbon monoxide, aff ect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
!
DANGER
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
!
5. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated below.
Installation
QUALIFIED
INSTALLER
34
To Next Page
Loading...
