20
Overview
Fire On/Off Wall Switch
(supplied, recommended)
Hearth (if used) may be
combustible material.
Minimum 1/2” (13 mm) gap
required below backing plate
to surface of hearth or fl oor in
front for air fl ow. Raise enrtire
unit accordingly.
Note: Unit projects
forward of fi nished
wall. Allow for tile,
etc.
Backing Plate required
(sold separately)
Bezel with barrier
screen required
(sold separately)
650J
Field convertible
from top to rear
outlet
Framing—See Framing section
Remote Handset Wall Holder
Wall Finish
May be combustible material.
NOTE: Finished wall surface, includ-
ing tiles, etc., MUST be minimum 3/4”
(19 mm) set back from the front face
of the heater.
Combustible fram-
ing allowed beneath
fi replace. When the
appliance is installed
directly on carpeting,
tile or other combus-
tible material other
than wood fl ooring,
the appliance shall be
installed on a metal or
wood panel extend-
ing the full width and
recessed depth of the
appliance.
Min.
3/4”
(19 mm)
Min. 1” (25 mm) for
combustible material
Note: This appliance may be installed in outdoor,
weather protected environments as defi ned in
the GV60CKO Outdoor Conversion
Kit instruction manual.
WARNING
HOT HEARTH / FLOOR! The hearth or fl oor
in front of the fi replace may become very
hot when the fi replace heats. Do not use the
hearth as a seat or shelf. Solid wood fl ooring
in front of the fi replace (if allowed) may
shrink during the heating season due to heat.
WARNING
Some materials or items, although safe,
may discolor, shrink, warp, crack, peel, and
so on because of the heat produced by the
fi replace. Avoid placing candles, paintings,
photos, and other items sensitive to heat
around the fi replace.
! !
QUALIFIED
INSTALLER
To Next Page
Loading...
