21
Mantel depth “A”
0–2”
(0–51 mm)
2–4”
(51–102 mm)
4–6”
(102–152 mm)
6–8”
(152–203 mm)
8–10”
(203–254 mm)
10–12”
(254–305 mm)
Mantel height
“B”
31-1/4”
(794 mm)
34”
(864 mm)
35”
(889 mm)
36”
(914 mm)
37”
(940 mm)
38”
(965 mm)
Dimensions
Mantel
36”
(914 mm)
min.
See table
Stand-off
Stand-off
See
table
A
B
23-1/8” (587 mm)
to rear vent center
16”
(406 mm)
26-3/4” (679 mm)
38-5/8” (981 mm)
32-3/16” (817 mm)
29-3/4” (756 mm)
30-3/4” (781 mm)
3” (76 mm) min.
To side wall from
inner frame
in front of
the appliance
8-1/4” (210 mm)
From finished
wall surface
to top vent
MINIMUM
3/4” (19 mm)
from finished
wall surface
to front of
appliance
MINIMUM 3/4” (19 mm)
clearance to combustible
at rear
Stand-off
16” (406 mm)
NOTE: Backing plate requires a MINIMUM of 1/2” (13 mm) space
to floor/hearth in front for air flow. Raise the appliance accordingly.
7-7/8”
(199 mm)
Fronts and Trims
For fronts and trims dimensions, refer to instructions
provided with each kit.
Floor/Hearth
This appliance is approved for installation directly on
combustible material such as plywood and so on. Vinyl,
carpet, and soft fl ooring require sheet metal extending
the whole width and depth under the appliance.
This appliance does not require a hearth. Combustible
fl ooring may extend up to the front of the unit.
Combustible Materials Specifi cations
Materials made of or surfaced with wood, compressed
paper, plant fi bers, plastics, or other material that
can ignite and burn, whether fl ame proofed or not,
or plastered or unplastered shall be considered
combustible materials.
Non-Combustible Materials Specifi cations
Material which will not ignite and burn. Such materials
are those consisting entirely of steel, iron, brick, tile,
concrete, slate, glass or plasters, or any combination
thereof.
Materials that are reported as passing ASTM E 136,
Standard Test Method for Behavior of Materials in a
Vertical Tube Furnace at 750 °C shall be considered
non-combustible materials.
QUALIFIED
INSTALLER
To Next Page
Loading...
