EasyManua.ls Logo

Valor H4 Series - Operating Your Fireplace; Fireplace Control Devices; How to Turn Your Fireplace off (Including Pilot); How to Ensure Your Fireplace Cannot be Turned on Inadvertently

Valor H4 Series
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Fireplace Control Devices
There are two ways to control your replace.
1. Thermostatic Remote Control;
2. Wall Switch.
The Thermostatic Remote Control can be pro-
grammed to function automatically—see details
starting on page 8.
The Wall Switch can be used to turn on, o and to
increase or decrease the ame height—
see page 12.
NOTE: The remote control in the AUTO mode will
override the wall switch.
How to Turn Your Fireplace OFF (including
pilot)
Familiarize yourself with each of these methods before
operating your replace.
Handset and Wall Switch: Press and hold the OFF
button for a second (either on the handset or the wall
switch).
If the ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
In the unlikely event that you cannot turn o your
replace with the remote control handset, use the
wall switch (if installed); if the wall switch malfunctions
and will not turn o the replace, wait 6 hours and the
replace will automatically go to pilot. You can then
access the controls inside your replace.
Alternately, turn o gas supply. In all cases, call your
dealer for service assistance.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your replace will not turn on when you
don’t want it on.
Turn the dial on the gas valve from the ON position
to the MAN position as shown. Turning the dial to
MAN (arrow up) will ensure that the main burner can
not come on. The pilot will remain on if it is lit.
Alternately, remove all batteries from the
receiver as well as the battery from the handset.
Automatic Shut-O (in certain conditions)
Your replace’s remote control is equipped with an
automatic shut-o mechanism which is activated in
certain conditions. See page 11 in the Using the
Remote Control section for a description of this feature.
Operating Your Fireplace
WARNING
RISKS OF SEVERE BURNS! SURFACES OF
THE FIREPLACE ARE VERY HOT DURING
OPERATION! Be very careful and wear gloves to
access controls.
!
ON: parallel to pipe
OFF:
perpendicular
to pipe
Wall Switch
Thermostatic
Remote Control
Gas valve
Gas valve
under window
Thermostatic
Remote Control
Wall Switch
OWNER’S
INFORMATION

Related product manuals