38
Top
Bottom
1. Install the Front Support Platform in the fi rebox
carefully sliding it down between the burner
and the front bottom edge for the fi rebox while
avoiding scraping the side ceramic panels.
2. Place the rock ceramic base on the log support
behind the burner. The front bottom of the base
must rest against the front lip of the log support.
3. Install the ceramic platform in the fi rebox
rotating down to insert the front fi rst behind
the Front Support. Lay the back of the ceramic
platform against the rear ceramic panel again
being careful not to scrape the ceramic panels.
Warning: This platform
is quite fragile. DO NOT
force it in place.
1
2
Fuel Bed Base
Installed
Install 534RSK Ceramic Rocks
Unpack the ceramic rocks kit very carefully to avoid damaging the fragile material. Install the components as shown
below. Please note that the position of the rocks and twigs (if used) is critical to ensure proper performance
of the appliance.
Installation
QUALIFIED
INSTALLER
To Next Page
Loading...
