Valor H4 Series - Refi T and Check Window, Install Window Baffl E

42
(appliance shown without its front frame and baffl es for clarity)
Rear view detail—window assembly with window
baffl e hooked on frame
Appliance front view
Window Baffl e
Installation
Refi t and Check Window, Install Window
Baffl e
1. Slide the window inside the appliance case and rest
it on the fi rebox front bottom tabs. Refi t the bottom
two bolts. The bolts should be screwed in securely.
2. Refi t the top two bolts securing by turning them
through 90 degrees.
3. Hook the window baffl e to the top of the window
frame. Be careful not to hook it onto the fi rebox
frame—see images below.
appliance top frame
window frame
cut out heat baffl e
(for clarity)
window baffl e
window baffl e
4. Grab the top of the window and baffl e and pull them
forward and release to check that the window opens
slightly and returns confi rming the good function of
the spring-loaded mechanism.
5. Similarly check the bottom of the window by pulling
it forward and releasing.
6. Apply fi rm hand pressure around the window frame
to ensure the window is sealed tight against the
fi rebox.
WARNING
Failure to install the window correctly can
leak carbon monoxide, aff ect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
!
DANGER
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the window frame is
correctly installed;
• Verify that the bolts and spring-loaded bolts
are hooked properly to the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
!
fi rebox
frame
window
frame
window
baffl e
QUALIFIED
INSTALLER