21
• 1440P+720P at 30 FPS
• 1080P+1080P at 30 FPS
• 1080P+720P at 30 FPS
• 720P+720P at 30 FPS
• Front Recording:
• 3840 × 2160P at 30 FPS
• 2560 × 1440P at 30 FPS
• 1920 × 1080P at 30 FPS
• 1280 × 720P at 30 FPS
• Loop Recording: Default setting is 1 minute. Options include 1/3/5 minutes and OFF.
• IR LEDs: Default setting is Auto. Options are Auto/Off/On.
• G-Sensor: Select the G-sensor sensitivity level and set it in one of the three directions
(Front + Rear/Left + Right/Up + Down). Sensitivity values range from 1 to 5, or Off.
Higher sensitivity levels trigger event recording more easily, with 5 being the most
sensitive.
• Privacy Mode: Default is off. You can enable it to record in private mode.
• Audio Recording: Default is ON. Choose between on or off.
• Exposure: Adjust exposure separately for the front/inside/rear car cameras. Default
is +0.0.
• REC Status Light: Default is ON. Choose to turn on/off the recording status light.
• HDR: Default is on. Adjust HDR separately for the front, interior, and rear cameras.
• Rotate Display: Default is off. Choose to flip the video screen up and down (180
degrees) for the front + cabin and rear camera.
• Mirror: Default is on. When on, the cabin and rear camera screens are displayed in
mirror mode.
• Number Plate: Select and set the number or letter to display on the recorded video.
• Stamp: Enable or disable the watermark stamp on video and photos, which includes
time and date label, VANTRUE label, license plate number, GPS location information,
and speed label. All enabled by default.
• Time Lapse: Default is disabled. Choose to enable 1FPS/5FPS/10FPS/15FPS.
• Parking Mode: Select the parking mode, including Collision Detection/Motion
Detection/Low Bitrate Recording/Low Framerate Mode/OFF.
• Low-light Night Vision in Parking Mode: Default is on, optimizing the recording
effect of videos in parking mode when turned on.
• Motion Detection Area: Adjust the motion detection range separately for the front
and rear areas of the car.
• Mileage Statistics: Default is on. With this function on, the dash cam records
mileage information, which can be exported through the mileage statistics function
in the app.
• GPS Settings: GPS is enabled by default. Here, you can configure GPS ON/OFF
settings, speed unit settings, and GPS information.
To Next Page
Loading...
Need help?
General
