➢ Mothball the blades on the cutting disc.
➢ Remove all dirt and plant remains.
➢ Repair damaged places on colour parts.
➢ Empty petrol tank and carburettor (for further instructions see engine user manual).
➢ Carry out seasonal lubrication of the cutter according to Table 6.
➢ Check tyre pressure and fill the tyres to MAX level.
2.5.7.1 Machine washing and cleaning
Follow local laws protecting water courses and other water resources from chemical contamination when cleaning the cutter.
Never wash the engine with a stream of water! The electrical equipment of the engine might be damaged on starting the engine.
Do not use pressure washers for cleaning the cutter.
2.5.8 Cover and machine disposal after its service life termination
You are required to carry out the package disposal after unwrapping the cutter, following national waste laws and regulations.
We recommend to follow these instructions when disposing of the machine after its service life termination:
➢ Dismount all machine parts that can still be used.
➢ Empty oil from gearbox and engine into an appropriate tank and hand it in at a collection point
67
.
➢ Dismount plastic and coloured metals.
➢ You are required to carry out the disposal of the dismantled machine remainder and dismounted parts, following national waste laws and
regulations.
2.5.9 Instructions for ordering spare parts
This user manual does not include a list of spare parts. The latest version of our catalogue can be downloaded from our web pages. If you do not have
Internet access, you can order the catalogue in printed form (against COD). In order to identify your machine properly you need to know its Type, Order
Number (CN°) and Identification Number (N°). These are given on the nameplate of your machine in the box, or in the warranty certificate. It is only
possible to find proper spare part designation with this information.
Field Description
Type Machine type designation. (DS-521D)
N° Unique manufacturer identification number.
1001401046.0110.00008 (product.month-and-year.consecutive-number)
CN° Business (order) number. (4238)
Tab. 9: Nameplate - example
2.6 Manufacturer address
VARI,a.s. Phone: (+420) 325 607 111
Opolanská 350 Fax: (+420) 325 607 264
Libice nad Cidlinou (+420) 325 637 550
289 07 Czech republic E-mail: vari@vari.cz
Web: http://www.vari.cz
2.7 Picture appendix
The picture appendix is common for all the language versions. You can find it at the end of this manual in the Chapter Pictures.
1) Place for holding at the back (frame U-tube)
2) Screen holder
3) Dismounted disc cover
4) Place for holding the machine at the front(cutting disc)
5) Tilted handlebars in the package (transport position)
6) Bag
7) Side and rear screens
8) Dismounted parts of lower cover
Pict. 1: Unwrapping the machine
67 Collection point information is given by responsible local office.
26
To Next Page
Loading...
Need help?
General
