ProStar 430 Autosampler Control Manual - 18 - 03-914947-33:2
Alternatively, syringe speeds can be reduced by entering a
Scale Factor. The syringe speed will be the Scale Factor
multiplied by the Syringe speed. The speed of the syringe
during the wash or the rinsing procedure of the buffer is not
affected by this setting.
The Needle height is the distance between the needle point
and the plate holder (default: 5 mm ; range: 0-40 mm). This
value is only used in injection modes (this value is
programmable in case of mix).
To Next Page
Loading...
