ProStar 430 Autosampler Control Manual - 3 - 03-914947-33:2
Installation and Configuration
Installing the Driver Software
To install the Galaxie Drivers software refer to the Galaxie installation
Guide.
Configuring the Communication Server
To communicate with the ProStar 430 module an RS232_Interface or
RS232_PC communication bus must be configured on the acquisition
server.
The parameters of the bus must be the following:
Stops
1 Stop
Baud 19200
Parity EVEN
Bits 8 Bits
Flow Control NONE
Buffer Tx 4096
Buffer Rx 4096
NOTE: For more details about the configuration of an RS232_Interface or RS232_PC
bus, refer to the Galaxie Chromatography Data System Installation’s Guide.
To Next Page
Loading...
