A rattling sound from the closed part of the mixer. Adjustment of special V-belt
The mixer starts “striking” when kneading dough Adjustment of special V-belt
which normally causes no problems.
The mixer changes its speed by itself. Adjustment of special V-belt
The minimum and the maximum speeds are changing. Adjustment of speed.
The bowl is too tight or too loose. Adjustment of bowl xing
The tool hits the sides of the bowl. Adjustment of bowl centering
The tool hits the bottom of the bowl. Adjustment of bowl height
The distance is only indicative as it depends on the
tolerance of the special V-belt.
Start by tightening the V-belts (
*
2. Tighten the special V-belt by moving one or two wash-
ers from to .
3. Start the mixer and leave it running while the nut is
tightened. Do not tighten it too much.
4. On the front pulley set the stud on the Varispeed collar
must be placed inside the lower fork and on the
rear pulley set outside the fork for belt tightener , (both
must point backwards).
5. Tolerances in the transmission might cause that the spe-
cial V-belt is hitting the pins of the pulley sets when
the speed has been adjusted. In such cases the distance
must be reduced. (+ or - 1/8" of 12 1/4")
6. Then follow the section:
The stop screws on the speed lever should
be adjusted so that the measurement is
on the front and the rear pulley, at low and high speed,
respectively. Tighten the counter nuts when the speed
is correctly adjusted.
2. Tolerances in the transmission might cause that the
special V-belt is hitting the pins of the pulley sets
when the speed has been adjusted In such cases the dis-
tance must be reduced, see
, and the speed must be readjusted.
To Next Page
Loading...
