9
-
cation interval of approx. 60 hours of operation.
. Special grease !!(Use the grease gun delivered together with
the mixer). Start the mixer and increase the speed to approx. 50%.
Stop the mixer (use the emergency stop) and open the lid on the
top of the mixer. On the top of each of the two pulley set shafts is
a grease nipple . Press grease through the grease
nipples.
until the grease gun feels hard to press or until grease comes out
between the shaft and the pulleys.
The mixer must not be started until the screws which
hold the lid are inserted.
Start the mixer, and set the speed back to low speed.
ready for next time.
The movable parts of the bowl arms, the shaft and the lifting rod
must also be lubricated with oil. Remove the rear covering and
lubricate the marked points with an oil can.
Pulley set shafts: .
Planetary head: Only to be repaired by an authorised technician.
Toothed wheel and the toothed rim
special grease
Needle bearings Special grease 2.
On repair of the attachment hub: Fill the attachment hub
with
Do not use any another type of grease than the one stated here.
1 2 3 4 5
MIN MAX
To Next Page
Loading...
