K6/K6N Vacuum Packaging Machine
Installation of the machine
2002-04-25 Art. no. 519.340 Page 20/56
§ Close the two filler necks.
§ Allow the vacuum pump to run for a short time, then check that the oil level is correct in the upper
inspection glass.
§ Fit the panelling sheets back onto the machine.
7.4 Cleaning the machine
§ Remove any adhesive tape or other material left over from the packaging. Clean the vacuum
chamber and the vacuum chamber lid thoroughly. No dirt may get into the suction nozzle. The
section on “Cleaning” contains information on suitable detergents.
To Next Page
Loading...
