Vectrix VX-1 - Page 51

4-9
D
E
The center instrument cluster monitors the following:
D. The speedometer needle indicates the charge current
times (X) 10 on the km/h scale (example 100 km/h
indicates 10 amps).
E.Theodometerelddisplaysthechargemodeandthe
voltage limit. The charge modes are:
“CC xx” = Constant current XXX is the target voltage.
“CV xx” = Constant Voltage.
“EC xx” = End of Charge and termination code.
This indicates the reason for the termination (049 is
normal).
“dE xx” = Delay mode.
Cool down delay is active, the delay time remaining
is shown on the left instrument cluster’s clock reading
display xx is the target voltage.
Itwillalsodisplayhighandlowcellvoltage(exampleHigh
3.45Low3.44).
Display During Charging: