Wiring/Miscellaneous For TLS-IB Consoles W/RS-232 & RS-485 TLS-IB Specifications
5-9
WIRING CONNECTIONS
The TLS-IB SCI wiring connections to J3 (on TLS-IB CPU/Power Supply Board, see Figure 5-2 on page 5-3) are
shown in Table 5-2.
SERIAL INTERFACE COMMANDS
Veeder-Root RS-232 command protocol format applies. Table 5-3 lists the serial commands recognized by the
TLS-IB:
Table 5-2. SCI Wiring Connections
TLS-IB J3 Connector Laptop Serial Port Connector
RS-232 Serial Interface
A (receive) TXD (pin 2)
B (transmit) RXD (pin 3)
G (signal ground) GND (pin 5 DB9, pin 7 DB25)
RS-485 Serial Interface
A (receive) A
B (transmit) B
G (signal ground) G
Table 5-3. TLS-IB Serial Commands
Command Description
001 System Reset
002 Clear Power Reset Flag
003 Remote Alarm Reset
201 In-Tank Inventory Report (height, water, and temp only)
205 In-Tank Status Report
214 In-Tank Mass/Density Inventory Report
233 Density Offset History Report
234 In-Tank Mass/Density Inventory Report 2
504 Set RS-232 Security Code
50D Set Print Temperature Compensation Flag
50E Set Temperature Compensation Value
514 Set H-Protocol Height/Volume Format
517 Set System Type & Language Flags (ext. lang. set)
To Next Page
Loading...
