Vega VEGAPULS 67 - Set up with the Display and Adjustment Module; Insert Display and Adjustment Module

12
5 Set up with the display and adjustment module
VEGAPULS 67 • HART and accumulator pack
47154-EN-210621
5 Set up with the display and adjustment
module
5.1 Insert display and adjustment module
The display and adjustment module can be inserted into the sensor
andremovedagainatanytime.Youcanchooseanyoneoffourdier-
ent positions - each displaced by 90°. It is not necessary to interrupt
the power supply.
Proceed as follows:
1. Unscrew the housing lid
2. Place the display and adjustment module on the electronics in the
desired position and turn it to the right until it snaps in.
3. Screw housing lid with inspection window tightly back on
Disassembly is carried out in reverse order.
Thedisplayandadjustmentmoduleispoweredbythesensor,anad-
ditional connection is not necessary.
Fig. 8: Installing the display and adjustment module in the electronics compart-
ment of the single chamber housing