Velocity PHANTOM II - Before Leaving Jobsite; Installation Completion Checklist

64
PHTM II
Installation, Operating & Service Instructions
110331-01 - 5/20
17 Before Leaving Jobsite
Before leaving jobsite:
 Installed ASSE 1017 or 1070 tempering valve
 Installed wall retaining clips (bottom)
 Flushed heating system
 Boiler and system filled with water
 Air purged from boiler system
 No loose, uninsulated or miswired connections
 Checked for gas leaks
 Checked gas inlet pressure
 Performed combustion test
 Screw cap in vent adapter
 No errors or holds present on display
 Tested additional field installed controls for functionality outlined by manufacturer (i.e. LWCO, high
limit, or other controls)
 Set proper CH temperature set point
 Set proper DHW temperature set point
 Tested DHW operation to confirm tempering valve setting
 Verify system pump operation
 Adjusted heating thermostat to its final set point
 Checked all valve and control settings
 Reviewed User’s Information Manual and system operation with owner/operator