Velodyne MicroVee User Manual

www.velodyne.com
MicroVee User’s Manual - 1
CONGRATULATIONS
Congratulations on your purchase of a Velodyne MicroVee subwoofer system! This system represents the state-
of-the-art in low frequency reproduction and will provide you with years of listening pleasure when properly
used and cared for. Read and follow this instruction manual to insure safe and proper system connection and
operation.
Note: Do not leave unit in direct sunlight or use in high humidity environments!!!
Warning!
To prevent re or shock hazard, do not expose this equipment to rain or moisture. To avoid electrical shock, do
not open speaker enclosure or amp chassis cover. Please observe all warnings on the equipment itself. There are
no user serviceable parts inside. Please refer all service questions to your authorized Velodyne dealer or service
representative.
Prior to Installation:
Please unpack the system carefully. This unit is heavy. Use caution when lifting or moving to avoid injury. Four
rubber feet are included with your subwoofer and are located in the styrofoam packing. Before installing your
MicroVee, peel o the adhesive backing and attach the feet to the bottom of the subwoofer.
Please save the carton and all packaging materials for future use. Packing this unit in any other carton may
result in severe damage when shipping. Record the serial number in the space provided on the warranty card
for future reference.
Product Features
• Drivers consisting of:
- Active 6.5” (5” piston diameter) driver with 2” high-temp voice coil and,
- Dual passive radiators 6.5” (5” piston diameter)
• Built-in 2000 watt Dynamic/1000 watt RMS high eciency Class D amplier
• Adjustable (50 to 200 Hz) low-pass crossover (defeatable)
• Line-level (mini-jack) inputs and outputs
• LFE Input
• Speaker-level inputs
• Speaker-level outputs with 120 Hz high-pass crossover
• Signal sensing auto turn on/o (active/inactive)
• Variable volume control
• Selectable phase control (0° or 180°)
• Multiple staggered low-pass crossovers; 12 dB/octave initial, 48 dB/octave ultimate
• Driver Displacement Control circuit to prevent over excursion and amp clipping
• High-excursion rubber surround
• Oversized spider for linearity at high excursion
• Slot loaded bass reex design

Velodyne MicroVee Specifications

General

Weight	20 lbs
Phase	0 or 180 degrees
Enclosure Type	Sealed
Inputs	Line-level
Finish	Black
Driver Size	6.5 inch forward firing, 2 x 6.5 inch passive radiators
Low Pass Crossover	50 Hz - 200 Hz (12dB/Octave)