Walk assist interface
Long press button to enter the walk assist mode, interface as shown below:
Error code indication interface
When the display receives the error info returned by controller, it will show detailed error code
on interface, indicating relevant electrical system fault information. The error code will be
displayed numerically in the speed display area.
Setting interface
Within 10s after turning on display, long press M button to enter setting interface, short press 、
to switch between setting interfaces. In any setting interfaces, short press M to enter parameter
editing state, which offers two modes, picking and selecting. The picking mode is indicated by triangle
cursor on the right, and selecting mode is indicated by parameter shown on white background. Short
press 、 to modify the parameters to edit. Long press M button to confirm and exit editing state,
and long press M button again to return to previous page.
Short press 、 button to enter into each setting item accordingly.
To Next Page
Loading...
Need help?
General
