VeloFox DM03 - Page 16

杭州威狐智能科技有限公司
Hangzhou VeloFox Intelligent Technology Co,. Ltd.
文件编号
版本号
1.01
第16 页/共 27页
no power output from the motor, and disabled assist level switch. Power assist level is displayed as
OFF or 0.
To get out of low-voltage mode, reset, and increase the voltage above low-voltage value and
battery capacity above 5%.
Percentage of battery power（C）and power level table
（Require battery % info from BMS or controller）：
SOC
Battery level
Description
80% ≤ SOC
Full battery level 5
60% ≤ SOC < 80%
Level 4
40% ≤ SOC < 60%
Level 3
20% ≤ SOC < 40%
Level 2
10% ≤SOC < 20%
Level 1
5% ≤ SOC < 10%
Level 0
0% ≤ SOC < 5%
Level 0 and icon blink at 1Hz
⚫ Remarks about battery indicator：
When there is a battery communication error：
1. Display will estimate the power according to the voltage and show the battery level
accordingly；
2. No battery percentage information shown；
3. Range information will not be displayed；
4. If the voltage is lower than the low-voltage value, the effect of the current on voltage needs to be
considered when converting to voltage at 0 current