VeloFox DM03 User Manual

杭州威狐智能科技有限公司
Hangzhou VeloFox Intelligent Technology Co,. Ltd.
文件编号
版本号
1.01
第22 页/共 27页
Current
limit setting
CurLtd= current
limitation
Value= 0-31.5A
Default Value：
12
Step=0.5A
Controller’s
current limit
setting
System
voltage
setting
SysVol= select
system voltage
Value=
24V/36V/48V
Default value：
36V
Choose system
voltage
Low
voltage
protection
setting
LowVol= low
voltage level
Value= 10.0-
52.0V
Default value：
31.5V
Step=0.5V
Select the low-
voltage value
for protection
* Note: The wheel diameter option CCF is the wheel diameter perimeter setting, which needs to be
supported by the controller communication protocol. Parameter 29 = wheel diameter of 29 inches,
which needs to be supported by a corresponding controller communication protocol. When the CCF
value is selected for the wheel diameter parameter, customer is allowed to customize the wheel
diameter circumference value (four-digit length value in mm).
Wheel diameter input operation：Short press 、 button to enter the parameter value, short
press M button to switch to the next number, long press M button to confirm each digit input. After
confirming the wheel diameter value input, long press M button to exit the current setting and return
to previous menu. The type of wheel diameter configuration will be recorded to the controller. If
customer confirms wheel diameter CCF option, then CCF page will be displayed directly when
entering the wheel diameter setting.

VeloFox DM03 Specifications

General

Brand	VeloFox
Model	DM03
Category	Monitor
Language	English