Ventrac LE3200 - Fuses; Inspection of Belts

Service - 36
Fuses
A
A
B
B
C
C
D
D
E
E
F
F
G
G
H
H
Ref Letter
Circuit Fuse Size
A Start/ PTO 15
B PTO Switch 5
C Engine Relay #1 5
D 12 Volt (Optional) 15
E Engine Relay #2 15
F Preheat and Alternator 5
G Dash Panel 5
H Light Switch 15
Changing the Fuses
1. Park the power unit on a level surface.
2. Shut off engine and engage park brake.
3. Remove ignition key from switch.
4. Identify and pull defective fuse from socket.
5. Push new fuse into socket. Be certain to have
proper size fuse or damage may occur to the
power unit.
Inspection of Belts
Periodically checking the belts on the Ventrac 3200
can prevent sudden failure by fi nding problems
before they cause the belt to break. It is recom-
mended to inspect all belts every 50 hours of opera-
tion, or if a problem is suspected. There may be a
belt problem if there is a squealing or chattering
sound, or the smell of a slipping belt.
SERVICE