40
OPEN : Hold operation switch until room seals tightly on the
exterior of the unit. DO NOT distort or bend the exterior flanges or
interior fascia by holding the switch in the “ON” position.
CLOSE : To retract, reverse the procedure and hold button until the
room is fully inside with gaskets sealing to the outer wall. It takes about
20 seconds to move the slide in or out.
VENTURE RV does NOT require or suggest blocking, supports,
jacks, etc., to be used under slide outs during extended normal use.
Electrical Components
A 12 volt DC motor is located under the frame. It may be inside of main
rail on frame, or on some models it will be on the outer side on main rail
along with front to rear shaft. On the above floor slide, it will be under
the floor of the sofa or dinette. The in wall slide room system motors are
installed in the wall.
Operational switch: This switch, is a three position, (off
center, in or out) spring loaded switch. Select which
direction you wish to move the room. Press on desired
position and hold until room is seated, and gasket is
slightly compressed. Do not force the room to move
beyond sealing as damage could occur.
When opening slide room, DO NOT over-extend. Fascia board can be distorted,
loosened or bent from correct position
CAUTION
!
Stand clear of the room’s interior path and verify that the room’s exterior path is
clear before extending or retracting the room.
WARNING
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
