51
requiring unit to be level or slightly up in front. Others will drain from
end permitting a slight tilting to the side which drains are on.
Remove the cap and attach the adapter onto the valve housing.
Turn the adapter 10º to lock onto the pegs. Attach a flexible sewer
hose to the adapter and secure with a clamp. Place the other end
into the approved sewer system.
You may now open the 3 inch drain valve to drain the sewage tank
first. Open the valve on the gray water tank last to utilize water to
wash and rinse the hose and drain lines.
Most states and parks have strict laws and regulations to prohibit
dumping of wastes of any kind into anything other than proper
disposal facilities or sewer systems. Almost all privately owned
parks have either a central pump facility or offer a campsite hookup
for sewage. You can find lists of many dump facilities throughout
the United States in Woodall’s, Rand McNally Camp Guide, Good
Sam Camp Guide, KOA Campgrounds Camp Guide, or various
other publications. Some fuel stations also have dump stations.
BLACK TANK FLUSH SYSYTEM—OPTIONAL
The flush system is designed and built to rinse the waste holding
tank, AFTER waste tank has been drained completely of water and
solids.
1. Attach a fresh water source to the connection marked “Sewer
Tank Flusher”. Be sure termination valves are open on tanks.
2. Open valve to release water into tank for rinsing and cleaning of
your waste water holding tank.
3. Rinse for several minutes to remove any foreign matter from
tank, and probes.
Remember the moisture content may give you a false reading on
your monitor panel indicating it is full. Allow time to dry out tank or
recharge for next usage.
It is important to use adequate water to flush and have several gallons of
water with chemicals in the tank. This helps the flow of wastes and reduces
solid waste build-up.
CAUTION
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
