S4: Reception status button (this is located at the 8 o'clock position (bottom left)). Press
this recessed button once when in normal time mode. If the radio signal reception was
successful the watch will speak the country name set to followed by "Time updated". If
the radio signal reception failed the watch will speak the country name set to followed by
"Time not updated".
Please note: In some poor reception areas the signal may not update every night.
Try moving the watch to a new location. However, the watch is very accurate and it
can miss a few nights updating without any serious loss of accuracy.
Operation
Receiving the time signal
During the night position your watch face down on a flat surface near a window. The
signal will be updated at 3am. You can test this by pressing the S4 (8 o'clock) button for
a reception status. If your watch is unable to make contact with the radio signal, it will
continue to function in the same way as a standard watch. The time will then be
corrected the next time your watch receives the time signal.
Country signal selection
You can set your watch to receive either UK, Germany, USA or Japan (60 KHz) signals.
When you select a new country the watch will adjust to the local time. The second hand
will run fast during the adjustment and then return to normal.
Selecting the signal for UK, Germany, USA or Japan (60 KHz
only)
Press S4 (8 o'clock) for about three seconds while the watch is in normal time mode until
the watch speaks “Set alarm, press 10 o’clock button to set”.
Press S4 (8 o'clock) another three times, until the watch speaks “Global signal selection,
only when you visit these countries. Press 10 o’clock button to set”.
Press S3 (10 o'clock).
After pressing S3, it says “Press 2 o’clock button to set, 8 o’clock button to confirm”.
To Next Page
Loading...