Push S4 (8 o'clock) once. If the reception was successful, the watch will speak the
country name followed by “Time updated”. If the reception failed, the watch will speak the
country name followed by “Time not updated”.
Set daily alarm
Press S4 (8 o'clock) for about three seconds while the watch is in normal time mode until
the watch speaks “Set alarm, press 10 o’clock button to set”.
Press S3 (10 o'clock).
The watch says “Press 2 o’clock button to set hour, 4 o’clock button for minute, 8 o’clock
button to confirm”.
Press S1 (2 o'clock) to set the hour and S2 (4 o'clock) to set the minute. The watch will
announce each hour and minute advanced in individual increments.
Press S4 (8 o'clock) to confirm after you have set the alarm time.
After confirmation, the watch will speak the alarm time set.
You can also check your alarm time set by pressing S3 (10 o'clock) at any time when in
normal time mode.
When activated the alarm will beep for 30 seconds at the alarm time set. Press any
button to turn off the alarm.
The alarm is a daily alarm, so it will alarm every day. To turn off the daily alarm, follow
the Alarm on/off setting described below.
Alarm on/off
Press S4 (8 o'clock) for about three seconds while the watch is in normal time mode until
the watch speaks “Set alarm, press 10 o’clock button to set”.
Press S4 (8 o'clock) one more time, and the watch speaks “Alarm On/Off, press 10
o’clock button to set”.
Press S3 (10 o'clock).
To Next Page
Loading...