Press S1 (2 o'clock) to select UK, Germany, Japan (60 KHz only) or USA. (If you set to
USA, you need to choose the correct time zone from Pacific, Mountain, Central or
Eastern).
Press S4 (8 o'clock) to confirm after a new country has been selected.
After confirmation, the watch will set to the local time of the country that you have
selected. Wait until the hands stop running and resume to normal.
Now your watch will show the local time of the country that you have selected. (It will
adjust for summer and winter time).
The watch will receive the local radio signal automatically overnight.
Manual signal reception
The watch must be set to the right country before it can receive an accurate signal (see
above).
Position the watch face down on a flat surface near a window.
While the watch is in normal time mode:
Press S3 (10 o'clock) until the second hand stops.
The second hand of the watch will stop at the following reference points:
7 o’clock for USA signal reception
12 o’clock for UK signal reception
12:01 for Germany signal reception
5 o’clock for Japan (60 KHz signal only) signal reception
(If the second hand is not at the positions stated above it may need re-calibrating. To re-
calibrate refer to the Troubleshooting section in these instructions).
The watch takes about five to 14 minutes to pick up the signal. Wait until the watch has
finished the signal receiving procedure.
After the signal reception, wait until the hands stop running and resume to normal.
To Next Page
Loading...