SERVICE FUNCTIONS
svcInfoPlatform()
M
X
800 SERIES PROGRAMMERS GUIDE 153
If feature = 3, then the value in result will be the amount of static RAM currently
installed in kilobytes.
If feature = 4, then the following bit values are returned, for multi-port cable status:
If feature = 5, then the following bit values are returned, for I/O module
configuration:
If feature = 6, then the following bit values are returned, for smart card version:
Table 10
Bits Definition Value
0 Multi-port cable type* 0 = Everest
1 = M
x
800 series
1 USB Type** 0 = Host
1 = Client
2 COM1 Configuration 0 = RS-232
1 = RS-485 (LAN)
3 COM3 Configuration 0 = RS-232
1 = RS-485 (ECR Tailgate)
4 COM1 Connection Detected** 1 = YES
5 COM2 Connection Detected** 1 = YES
6-15 Reserved
NOTE
If Everest type multi-port, then USB and Ethernet ports are not available.
NOTE
Connection to a powered DTE or DCE. These bits are valid only if the M
x
800
series terminal multi-port cable is detected.
Table 11
Bits Definition Value
0 Contactless/RFID 1 = YES
1 802.11 1 = YES
2 Biometrics 1 = YES
3-14 Reserved
15 O7xxx I/O module 1 = YES
Table 12
Bits Definition Value
0 Smart Card Version 1 (Delta) 1 = YES
1 Smart Card Version 1 (Delta2) 1 = YES
2-15 Reserved
To Next Page
Loading...
